Trigger:datatoclock:dsource[:Value]; Trigger:datatoclock:csource[:Value]; Trigger:datatoclock:csource:edge - Rohde & Schwarz Scope Rider Rth Benutzerhandbuch
Handheld-oszilloskop
®
R&S
Scope Rider RTH
Parameter:
<MinDuration>
TRIGger:SLEW:MAXWidth <MaxDuration>
Sets the upper time limit of the transition time for comparisons WITHin and OUTSide.
Parameter:
<MaxDuration>
15.3.5.11
Data2Clock-Trigger (R&S RTH-K19)
Siehe auch:
TRIGger:DATatoclock:DSOurce[:VALue] <Source>
Selects the input channel of the data signal.
Parameter:
<Source>
TRIGger:DATatoclock:CSOurce[:VALue] <Source>
Selects the input channel of the clock signal.
Parameter:
<Source>
TRIGger:DATatoclock:CSOurce:EDGE <Slope>
Sets the edge of the clock signal: rising (POSitive), falling (NEGative), or both
edges (EITHer). The time reference point for the setup and hold time is the crossing
point of the clock edge and the trigger level.
Benutzerhandbuch 1326.1578.03 ─ 19
Bereich:
Inkrement: 100E-9
*RST:
Std.-einheit: s
Bereich:
Inkrement: 100E-9
*RST:
Std.-einheit: s
Kapitel 3.6.11, „Data2Clock-Trigger (R&S
.............................................................................349
.....................................................................................350
...........................................................................................350
...........................................................................................350
C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST:
C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST:
800E-12 bis 10000
5E-9
800E-12 bis 10000
5E-9
RTH-K19)",
...........................................................................349
...........................................................................349
C1
C1
Fernsteuerbefehle
Einrichten von Messkurven
auf Seite 76.
349
Kapitel
