Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 431

®
R&S Scope Rider RTH
COUNter<m>:CALCulate:AVERage:MAXimum?
Queries the maximum of all measured counter frequencies since statistics were last
restarted.
Suffix:
<m>
Rückgabewerte:
<Maximum>
Verwendung:
COUNter<m>:CALCulate:AVERage:MINimum?
Queries the minimum of all measured counter frequencies since statistics were last
restarted.
Suffix:
<m>
Rückgabewerte:
<Minimum>
Verwendung:
COUNter<m>:CONFigure:FREQuency <Range>
This command sets all measurement parameters and trigger parameters to default
values for frequency measurements.
Note: this command can be executed at any time, even if the counter is not yet activa-
ted. The parameters are stored internally and used when the counter is activated.
Suffix:
<m>
Parameter:
<Range>
Benutzerhandbuch 1326.1578.03 ─ 19
.
1..2
Average measured value
Bereich: -100E+24 bis 100E+24
Inkrement: 1E-12
*RST: 0
Std.-einheit: Hz
Nur Abfrage
.
1..2
Average measured value
Bereich: -100E+24 bis 100E+24
Inkrement: 1E-12
*RST: 0
Std.-einheit: Hz
Nur Abfrage
.
1..2
<numeric value> | MIN | MAX | DEF
Defines the measurement range of the input signal for the coun-
ter. If probes are connected, the MIN | MAX | DEF values are
adapted accordingly.
Fernsteuerbefehle
Frequenzzähler (R&S RTH-K33)
431