Trigger:datatoclock:condition; Trigger:datatoclock:htime; Trigger:datatoclock:stime - Rohde & Schwarz Scope Rider Rth Benutzerhandbuch

®
R&S Scope Rider RTH
Parameter:
<Slope>
TRIGger:DATatoclock:CONDition <TrigCondition>
Selects how a violation of the setup time and hold time is handled.
Parameter:
<TrigCondition>
TRIGger:DATatoclock:HTIMe <HoldTime>
Sets the minimum time after the clock edge while the data signal must stay steady.
The hold time can be negative. In this case, the setup time has to be positive. The
setup time is defined by TRIGger:DATatoclock:STIMe.
Parameter:
<HoldTime>
TRIGger:DATatoclock:STIMe <SetupTime>
Sets the minimum time before the clock edge while the data signal must stay steady.
The setup time can be negative. In this case, the hold time has to be positive. The
setup time is defined by TRIGger:DATatoclock:HTIMe.
Parameter:
<SetupTime>
15.3.5.12 Trigger für serielle Muster (R&S RTH-K19)
TRIGger:SPATtern:DSOurce[:VALue]
TRIGger:SPATtern:CSOurce[:VALue]
TRIGger:SPATtern:CSOurce:EDGE
Benutzerhandbuch 1326.1578.03 ─ 19
POSitive | NEGative | EITHer
*RST: POSitive
VIOLation | OK
VIOLation
Triggers on a violation of the setup time or hold time.
OK
Triggers if setup and hold time keep the limits.
*RST: VIOLation
Bereich: -124E-9 bis 124E-9
Inkrement: 1E-9
*RST: 1E-9
Std.-einheit: s
Bereich: -124E-9 bis 124E-9
Inkrement: 1E-9
*RST: 1E-9
Std.-einheit: s
............................................................................... 351
............................................................................... 351
................................................................................. 351
Fernsteuerbefehle
Einrichten von Messkurven
350