Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 379

®
R&S Scope Rider RTH
SPECtrum:FREQuency:AVERage:COUNt <NoOfAvgs>
Defines the number of measurements to average for the average trace (see
SPECtrum:WAVeform:AVERage[:ENABle]
Parameter:
<NoOfAvgs>
SPECtrum:FREQuency:BANDwidth[:RESolution]:AUTO <State>
If enabled, the optimal resolution bandwidth is determined automatically by the spect-
rum application according to the frequency span and selected window type.
If disabled, the RBW is set according to the ratio defined by
BANDwidth[:RESolution]:RATio
Parameter:
<State>
SPECtrum:FREQuency:BANDwidth[:RESolution]:RATio <RBWRatio>
RBW ratio determines the resolution of the spectrum, which is: the minimum distance
between two distinguishable frequencies.
If you change the span, the RBW is automatically adjusted to the minimum or maxi-
mum allowed value, if necessary.
In FFT mode, this command is read-only.
Parameter:
<RBWRatio>
SPECtrum:FREQuency:FULLspan
This command is only available in Spectrum mode. It sets the displayed frequency
range to the entire measured span.
Verwendung:
Benutzerhandbuch 1326.1578.03 ─ 19
Bereich: 2 bis 1024
Inkrement: 2
*RST: 64
auf Seite 379.
ON | OFF
*RST: ON
R10 | R20 | R50 | R100 | R200 | R500 | R1K
R10
The value corresponds to the „RBW:Span Ratio" setting „1:10" in
manual operation.
R1K
The value corresponds to the „RBW:Span Ratio" setting
„1:1000" in manual operation.
*RST: R200
Ereignis
Fernsteuerbefehle
Spektrumanalyse
auf Seite 381).
SPECtrum:FREQuency:
379