Bus:can:fdata:dbitrate; Bus:can:fdata:dsamplepoint; Bus:can:fdata:enable; Bus:can:fdata:pstandard - Rohde & Schwarz Scope Rider Rth Benutzerhandbuch

®
R&S Scope Rider RTH
Parameter:
<ArbSamplePoint>
BUS:CAN:FDATa:DBITrate <DataCustomBitrate>
Sets the bit rate of the data phase. The data rate can be higher than the arbitration
rate, but it is uniform and fixed for a given CAN FD bus. Die Einstellung ist in der CAN-
FD-Option R&S RTH-K9 verfügbar.
Parameter:
<DataCustomBitrate> Bereich:
BUS:CAN:FDATa:DSAMplepoint <DataSamplePoint>
The sample point divides the data phase into two distinct time segments. The length of
the time segments is defined in time quanta according to network and node conditions
during CAN FD development. Die Einstellung ist in der CAN-FD-Option R&S RTH-K9
verfügbar.
Parameter:
<DataSamplePoint> Bereich:
BUS:CAN:FDATa:ENABle <State>
Enables the CAN FD protocol configuration. It BUS:CAN:FDATa:ENABle state is OFF,
then the CAN protocol is selected. Die Einstellung ist in der CAN-FD-Option R&S RTH-
K9 verfügbar.
Parameter:
<State>
BUS:CAN:FDATa:PSTandard <ProtocolStandard>
Only available for CAN FD buses. Selects if the tested signal is an ISO CAN FD signal
or not.
Parameter:
<ProtocolStandard> ISO | NISO
Benutzerhandbuch 1326.1578.03 ─ 19
Bereich: 10 bis 95
Inkrement: 1
*RST: 66
Std.-einheit: %
10000 bis 15000000
Inkrement: 1
*RST: 50000
Std.-einheit: bps
10 bis 95
Inkrement: 1
*RST: 66
Std.-einheit: %
ON | OFF
Fernsteuerbefehle
Protokollanalyse
476