Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 328

®
R&S Scope Rider RTH
TIMebase:RANGe <AcquisitionTime>
Sets the acquisition time, the time range across the 10 horizontal divisions of the dia-
gram. Use the command alternatively to TIMebase:SCALe.
Parameter:
<AcquisitionTime>
TIMebase:HORizontal:POSition <Position>
Sets the horizontal position of the trigger point in relation to the reference point.
See also:
Parameter:
<Position>
Time scale
1 ns/div to 100 µs/div
200 µs/div to 2 s/div
5 s/div – 500 s/div
TIMebase:REFerence <ReferencePoint>
Defines the time reference point in the diagram.
Parameter:
<ReferencePoint>
15.3.4 Erfassungssteuerung
............................................................................................................................. 329
RUN
STOP
ACQuire:MODE
ACQuire:AVERage:COUNt
ACQuire:ARESet:IMMediate
Benutzerhandbuch 1326.1578.03 ─ 19
Bereich:
Inkrement: Steps 1, 2, 5 (1, 2, 5, 10, 20, 50, 100, 200, 500...)
*RST:
Std.-einheit: s
„Horizontale Position (Horizontal Position)"
Bereich:
Inkrement: 0.1
*RST:
Std.-einheit: s
Position of the reference point in percent of the screen width.
Available values are:
10: on the left side of the screen
50: in the middle of the screen
90: on the right side
*RST:
Std.-einheit: %
........................................................................................................................... 329
............................................................................................................. 329
..............................................................................................329
........................................................................................... 330
10E-9 bis 5000
1E-6
auf Seite 52
Depends on the time scale, see table below.
0
Min./max. horizontal position
±2 s
Time scale * 20000
100000 s
50
Fernsteuerbefehle
Einrichten von Messkurven
328