Bus:uart:bitrate; Bus:uart:ssize; Bus:uart:parity; Bus:uart:sbit - Rohde & Schwarz Scope Rider Rth Benutzerhandbuch

®
R&S Scope Rider RTH
BUS:UART:BITRate <CustomBitrate>
Sets a user-defined bit rate if
Parameter:
<CustomBitrate>
BUS:UART:SSIZe <DataBits>
Sets the number of data bits in a word (symbol).
Parameter:
<DataBits>
BUS:UART:PARity <Parity>
Defines the optional parity bit that is used for error detection.
Parameter:
<Parity>
BUS:UART:SBIT <StopBits>
Sets the number of stop bits: 1 or 1.5 or 2 stop bits are possible.
Parameter:
<StopBits>
BUS:UART:ORDer <BitOrder>
Defines if a word starts with MSB (most significant bit) or LSB (least significant bit).
The display of the decoded signal considers this setting, results are displayed in the
specified order.
Benutzerhandbuch 1326.1578.03 ─ 19
BUS:UART:STDBitrate
Bereich: 300 bis 20000000
Inkrement: 1
*RST: 14400
Std.-einheit: bps
B5 | B6 | B7 | B8 | B9
*RST: B8
NONE | ODD | EVEN
NONE
No parity bit is used.
ODD
The parity bit is set to "1" if the number of data bits set to "1" is
even.
EVEN
The parity bit is set to "1" if the number of data bits set to "1" is
odd.
*RST: NONE
B1 | B15 | B2
*RST: B1
Fernsteuerbefehle
Protokollanalyse
is set to CUSTom.
469