Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 424

®
R&S Scope Rider RTH
Relative measurements are not available for diode, continuity, and frequency measure-
ments.
Suffix:
<m>
Parameter:
<ReferenceValue>
15.8.4 Messsteuerung
METer<m>:SENSe:FUNCtion
METer<m>:CONFigure:VALue?
METer<m>:TRIGger:MODE
METer<m>:ABORt
METer<m>:SENSe:FUNCtion <MeasType>
Sets the measurement type for the selected meter. All measurement attributes of the
previous function (range, resolution, etc.) are remembered. If you return to the previous
function, the measurement attributes are restored.
Changing the measurement type disables scaling, limit testing, histogram, statistics,
and trend chart data collection: CALC:<function>:STAT is set OFF.
Suffix:
<m>
Einstellparameter:
<MeasType>
Beispiel:
Verwendung:
METer<m>:CONFigure:VALue?
Returns the actual measurement type (short form) and the range.
Suffix:
<m>
Benutzerhandbuch 1326.1578.03 ─ 19
.
1..4
R&S RTH1002: always 1, omit the suffix
R&S RTH1004: Selects the voltmeter.
Bereich: +/- (1.1 * measurement range)
Std.-einheit: Depends on the measurement type
..........................................................................................424
....................................................................................... 424
............................................................................................ 425
......................................................................................................... 425
.
1..4
Selects the voltmeter.
'VOLTage:AC | VOLTage[:DC] | VOLTage:AD'
String parameter
*RST: VOLTage [:DC]
MET2:SENS:FUNC "VOLT:AC"
MET2:CONF:VAL?
<--"VOLT:AC 1"
Sets the second voltmeter to AC voltage measurement.
Nur Einstellung
.
1..4
Selects the voltmeter.
Fernsteuerbefehle
Voltmeter (R&S RTH1004)
424