Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 385

®
R&S Scope Rider RTH
SPECtrum:MARKer[:STATe] <State>
If enabled, a peak search is performed on the current spectrum results.
Parameter:
<State>
SPECtrum:MARKer:COUNt <NumberOfMarkers>
Defines the number of markers used to indicate peaks in the spectrum results. With 3
active markers, the 3 peak values in the spectrum are indicated.
Parameter:
<NumberOfMarkers> Bereich:
SPECtrum:MARKer:SOURce <TraceSource>
Determines the trace used for the peak search.
Parameter:
<TraceSource>
SPECtrum:MARKer:SETup:DISTance <Distance>
Defines a minimum distance between two frequencies that must be exceeded to detect
individual peaks.
Parameter:
<Distance>
SPECtrum:MARKer:SETup:EXCursion <Excursion>
Defines a relative threshold, the minimum level value by which the waveform must rise
or fall to be considered a peak. To avoid identifying noise peaks, enter a peak excur-
sion value that is higher than the noise levels.
See also
Parameter:
<Excursion>
Benutzerhandbuch 1326.1578.03 ─ 19
ON | OFF
*RST:
Inkrement: 1
*RST:
SPECtrum | MAXimum | MINimum | AVERage
*RST:
Bereich:
Inkrement: 10
*RST:
Std.-einheit: Hz
„Auslenkung" auf Seite 138.
Bereich:
Inkrement: 1
*RST:
Std.-einheit: dB
OFF
1 bis 15
3
SPECtrum
0 bis 500E+6
1E+6
0 bis 260
10
Fernsteuerbefehle
Spektrumanalyse
385