Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 359

®
R&S Scope Rider RTH
RTIMe
FTIMe
PPULse
NPULse
PDCYcle
NDCYcle
STDDev
PKPK
OVRShoot
PREShoot
PPCount
MEASurement<m>:AOFF
Disables all active measurements.
Suffix:
<m>
Verwendung:
MEASurement<m>:DELay:SLOPe <Slope>
Sets the slope for the delay measurement type.
Suffix:
<m>
Parameter:
<Slope>
Benutzerhandbuch 1326.1578.03 ─ 19
Rise time
Fall time
Positive pulse width
Negative pulse width
Positive duty cycle
Negative duty cycle
Standard deviation
Peak to peak
Overshoot
Preshoot
Positive pulse count
.
1..4
The suffix is irrelevant.
Ereignis
.
1..4
POSitive | NEGative | EITHer
POSitive
Delay between the first rising edge of each source waveform.
NEGative
Delay between the first falling edge of each source waveform.
EITHer
Delay between the first edge of each source waveform, no mat-
ter if it is rising or falling.
*RST: POSitive
Fernsteuerbefehle
Messkurvenanalyse
NPCount Negative pulse count
RECount Rising edge count
FECount Falling edge count
PWRP Active power
PWRS Apparent power
PWRQ Reactive power
PWRFactor Power factor
VPWM V RMS of PWM signal
FPWM Frequency of PWM
signal
VFPWm Ratio of V RMS and fre-
quency of PWM signal
359