Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 353

®
R&S Scope Rider RTH
TRIGger:INTerval:DELTa
TRIGger:INTerval:MINWidth
TRIGger:INTerval:MAXWidth
TRIGger:INTerval:SLOPe <Slope>
Sets the edge direction for the trigger. You can analyze the interval between positive
edges or between negative edges.
Parameter:
<Slope>
TRIGger:INTerval:RANGe <Condition>
Defines how the time range of an interval is defined.
Parameter:
<Condition>
TRIGger:INTerval:WIDTh <Duration>
Sets the time between two pulses for comparisons EQUal, UNEQual, SHORter, and
LONGer.
Parameter:
<Duration>
TRIGger:INTerval:DELTa <Tolerance>
Sets a range Δt to the specified width, which is defined using
WIDTh. The command is relevant for comparisons with conditions EQUal and
UNEQual.
Benutzerhandbuch 1326.1578.03 ─ 19
.................................................................................................353
............................................................................................ 354
...........................................................................................354
POSitive | NEGative
*RST: POSitive
LONGer | SHORter | EQUal | NEQual | WITHin | OUTSide
LONGer | SHORter
Triggers on intervals shorter or longer than an interval that is set
using TRIGger:INTerval:WIDTh.
EQUal | NEQual
Triggers on intervals equal or not equal a given interval width
that is set using TRIGger:INTerval:WIDTh. In addition, a
tolerance can be set around the specified width using
TRIGger:INTerval:DELTa.
WITHin | OUTSide
Triggers on intervals inside or outside a given range.
*RST: LONGer
Bereich: 800E-12 bis 10000
Inkrement: 100E-9
*RST: 5E-9
Std.-einheit: s
Fernsteuerbefehle
Einrichten von Messkurven
TRIGger:INTerval:
353