Digitalmultimeter (R&S Rth1002) - Rohde & Schwarz Scope Rider Rth Benutzerhandbuch

®
R&S Scope Rider RTH
Verwendung:
HARMonic:RESult<m>:RMS:MAXimum?
HARMonic:RESult<m>:RMS:MINimum?
HARMonic:RESult<m>:RMS[:CURRent]?
Returns the currently calculated, minimum, or maximum root mean square of the
power in the entire signal, for all harmonics and the fundamental frequency.
Suffix:
<m>
Rückgabewerte:
<RMS>
Verwendung:
HARMonic:RESult<m>:THD:MAXimum?
HARMonic:RESult<m>:THD:MINimum?
HARMonic:RESult<m>:THD[:CURRent]?
Returns the currently calculated, minimum, or maximum THD (total harmonic distor-
tion), that is: the RMS of the amplitude of the harmonics. Which value the THD is rela-
ted to, depends on the
Suffix:
<m>
Rückgabewerte:
<THD>
Beispiel:
Verwendung:
15.7 Digitalmultimeter (R&S RTH1002)
● Multimeter-Modus
● Messkonfiguration................................................................................................. 401
● Relative
● Messsteuerung......................................................................................................411
● Ergebnisse............................................................................................................ 412
Benutzerhandbuch 1326.1578.03 ─ 19
Nur Abfrage
.
1|2 (RTH1002) , 1..4 (RTH1004)
Bereich:
Inkrement: 1E-12
*RST:
Nur Abfrage
HARMonic:THDType
.
1|2 (RTH1002) , 1..4 (RTH1004)
Bereich:
Inkrement: 0.1
*RST:
Std.-einheit: %
HARM:THDT THDF
HARM:RES1:THD?
Returns the RMS amplitude (voltage or current) of the harmo-
nics relative to the RMS amplitude of the fundamental compo-
nent.
Nur Abfrage
aktivieren................................................................................. 401
Messungen..............................................................................................408
Digitalmultimeter (R&S RTH1002)
0 bis 100E+3
0
command.
0 bis 1000
0
Fernsteuerbefehle
400