Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 499

®
R&S Scope Rider RTH
BUS:SENT:CLKPeriod <ClockPeriod>
Sets the nominal clock period (clock tick).
Parameter:
<ClockPeriod>
BUS:SENT:CLKTolerance <ClockTolerance>
Sets a tolerated deviation of the clock signal.
Parameter:
<ClockTolerance>
BUS:SENT:CRCMethod <CRCCalculation>
Selects the calculation method for the CRC checksum.
Parameter:
<CRCCalculation>
BUS:SENT:CRCVersion <CRCVersion>
Selects the calculation method for the cyclic redundancy check (CRC).
Parameter:
<CRCVersion>
BUS:SENT:DNIBbles <DataNibbles>
Sets the number of data nibbles for a transmission sequence.
Parameter:
<DataNibbles>
Benutzerhandbuch 1326.1578.03 ─ 19
Bereich: 1E-6 bis 100E-6
Inkrement: 1E-6
*RST: 3E-6
Std.-einheit: s
Bereich: 0 bis 25
Inkrement: 1
*RST: 20
Std.-einheit: %
SAEJ | TLE
SAEJ: according to the standard
TLE: according to the computing method for TLE_4998X sen-
sors.
*RST: SAEJ
V2010 | LEGA
LEGAcy: method used up to 2010
V2010: current method
*RST: V2010
Bereich: 1 bis 6
Inkrement: 1
*RST: 3
Fernsteuerbefehle
Protokollanalyse
499