Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 325

®
R&S Scope Rider RTH
CHANnel<m>:BANDwidth <BandwidthLimit>
Selects the bandwidth limit for the indicated channel.
Suffix:
<m>
Parameter:
<BandwidthLimit>
CHANnel<m>:POLarity <Polarity>
Turns the inversion of the signal amplitude on or off. To invert means to reflect the vol-
tage values of all signal components against the horizontal display center. Inversion
affects only the display of the signal but not the trigger.
Suffix:
<m>
Parameter:
<Polarity>
CHANnel<m>:DESKew <Deskew>
Sets a delay for the selected channel.
Deskew compensates delay differences between channels caused by the different
length of cables, probes, and other sources.
Benutzerhandbuch 1326.1578.03 ─ 19
DCLimit
The signal passes the input unchanged.
ACLimit
A highpass filter removes the DC offset voltage from the input
signal if the DC component of a signal is of no interest.
*RST: DCLimit
.
1|2 (RTH1002) , 1..4 (RTH1004)
FULL | B350 | B200 | B100 | B60 | B50 | B40 | B20 | B10 | B5 |
B4 | B2 | B1 | B5HK | B4HK | B2HK | B1HK | B50K | B40K |
B20K | B10K | B5K | B4K | B2K | B1K
FULL
At full bandwidth, all frequencies in the specified range are
acquired and displayed.
B350 | B200 | B100 | B60 | B50 | B40 | B20 | B10 | B5 | B4 | B2
| B1
Limit to 350 MHz, 200 MHz, 100 MHz, 60 MHz,..., respectively.
B5HK | B4HK | B2HK | B1HK | B50K | B40K | B20K | B10K |
B5K | B4K | B2K | B1K
Limit to 500 kHz, 400 kHz,..., respectively.
*RST: FULL
.
1|2 (RTH1002) , 1..4 (RTH1004)
NORMal | INVerted
*RST: NORMal
Fernsteuerbefehle
Einrichten von Messkurven
325