Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 326

®
R&S Scope Rider RTH
Suffix:
<m>
Parameter:
<Deskew>
CHANnel<m>:THReshold:TECHnology <ThresholdType>
Sets the threshold value for digitization of analog signals. If the signal value is higher
than the threshold, the signal state is high (1 or true for the Boolean logic). Otherwise,
the signal state is considered low (0 or false) if the signal value is below the threshold.
Suffix:
<m>
Parameter:
<ThresholdType>
CHANnel<m>:THReshold:USER <ThresholdValue>
Set an individual threshold value if
USER.
Suffix:
<m>
Benutzerhandbuch 1326.1578.03 ─ 19
.
1|2 (RTH1002) , 1..4 (RTH1004)
Deskew value
Bereich: -100E-9 bis 100E-9
Inkrement: 800E-12
*RST: 0
Std.-einheit: s
.
1|2 (RTH1002) , 1..4 (RTH1004)
TTL | ECL | CMOS | CAN | GND | LIN7vsupply | LIN12vsupply |
LIN18vsupply | USER
TTL
1.4 V
ECL
-1.3 V
CMOS
2.5 V
GND
0 V (for CAN channels, requires option R&S RTH-K3).
CAN
2 V (for CAN channels, requires option R&S RTH-K3).
LIN7vsupply | LIN12vsupply | LIN18vsupply
7 V / 12 V / 18 V (for LIN channels, requires option R&S RTH-
K3).
USER
Set the value with CHANnel<m>:THReshold:USER.
*RST: TTL
CHANnel<m>:THReshold:TECHnology
.
1|2 (RTH1002) , 1..4 (RTH1004)
Fernsteuerbefehle
Einrichten von Messkurven
is set to
326