Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 449

®
R&S Scope Rider RTH
15.11.1 Allgemeine Protokolleinstellungen
BUS:TYPE
BUS[:STATe]
BUS:FORMat
BUS:TYPE <Protocol>
Defines protocol type of the bus for configuration and trigger settings.
Parameter:
<Protocol>
BUS[:STATe] <State>
Enables the decoding and the display of the serial bus data.
Parameter:
<State>
BUS:FORMat <NumberFormat>
Sets the decoding format of the data.
Parameter:
<NumberFormat>
15.11.2 I2C (Option R&S RTH-K1)
● I2C-Konfigurationseinstellungen........................................................................... 449
● I2C-Trigger............................................................................................................ 451
● I2C-Decodierungsergebnisse................................................................................453
15.11.2.1 I2C-Konfigurationseinstellungen
BUS:I2C:SCL:SOURce
BUS:I2C:SDA:SOURce
BUS:I2C:TECHnology
BUS:I2C:SCL:THReshold
BUS:I2C:SDA:THReshold
BUS:SETReflevels
Benutzerhandbuch 1326.1578.03 ─ 19
.................................................................................................................... 449
..................................................................................................................449
................................................................................................................ 449
I2C | SPI | UART | CAN | LIN | SENT
*RST:
ON | OFF
*RST:
BIN | OCT | DEC | HEX | ASCii
*RST:
...................................................................................................450
.................................................................................................. 450
.................................................................................................... 450
............................................................................................... 450
............................................................................................... 450
......................................................................................................... 450
I2C
OFF
HEX
Fernsteuerbefehle
Protokollanalyse
449