Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 432

®
R&S Scope Rider RTH
Verwendung:
COUNter<m>:CONFigure:VALue?
Returns the current configuration for the counter measurement defined by the most
recent
FREQuency?
Suffix:
<m>
Rückgabewerte:
<ConfigString>
Beispiel:
Verwendung:
COUNter<m>:FETCh?
Queries the currently measured value.
Suffix:
<m>
Rückgabewerte:
<ResultActual>
Verwendung:
COUNter<m>:INITiate
Resets the hardware and all statistical values, performs a single measurement and
ends in hold mode.
Benutzerhandbuch 1326.1578.03 ─ 19
<numeric value>
Power range in V. If necessary, the next higher range is selec-
ted.
MIN
100 mV
MAX
300 V
DEF
100 mV
Nur Einstellung
COUNter<m>:CONFigure:FREQuency
command.
.
1..2
String containing the current measurement function (FREQ) and
the defined measurement range of the used input channel.
COUN1:CONF:VAL?
//Result: 'FREQ 3V'
Nur Abfrage
.
1..2
Measured value
Bereich:
Inkrement: 0
*RST:
Std.-einheit: Hz
Nur Abfrage
Frequenzzähler (R&S RTH-K33)
or
COUNter<m>:MEASure:
-100E+24 bis 100E+24
0
Fernsteuerbefehle
432