Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 362

®
R&S Scope Rider RTH
Verwendung:
CURSor:MEASurement<m>:TYPE <Type>
Sets the automatic measurements to be performed on the source waveform between
the cursor lines. The setting is only available if
Suffix:
<m>
Parameter:
<Type>
15.4.3.2 Ergebnisse von Cursor-Messungen
CURSor:TDELta?
CURSor:ITDelta?
CURSor:X1Position
CURSor:X2Position
CURSor:DELTa?
CURSor:Y1Position
CURSor:Y2Position
CURSor:Y1AMplitude?
CURSor:Y2AMplitude?
CURSor:MEASurement<m>:RESult:ACTual?
CURSor:MEASurement<m>:RESult:LIMit?
CURSor:TDELta?
Returns the time difference Δ between to vertical cursor lines.
Rückgabewerte:
<ResultDeltaT>
Verwendung:
CURSor:ITDelta?
Returns the inverse value of the time difference between to vertical cursor lines1/Δt.
Benutzerhandbuch 1326.1578.03 ─ 19
Ereignis
.
1..2
Defines the measurement index. Two simultaneous cursor mea-
surements can be performed.
PERiod | FREQuency | RTIMe | FTIMe | PPULse | NPULse |
PDCYcle | NDCYcle | MEAN | RMS | CRESt | STDDev |
MINimum | MAXimum | PKPK | BASelevel | TOPLevel |
AMPLitude | AREA | OVRShoot | PREShoot | AC | DC | ACDC |
PPCount | NPCount | RECount | FECount | VPWM | FPWM |
VFPWm
See
MEASurement<m>:TYPE
*RST: MINimum
...........................................................................................................362
........................................................................................................... 362
........................................................................................................363
........................................................................................................363
............................................................................................................ 363
........................................................................................................363
........................................................................................................363
................................................................................................... 363
................................................................................................... 363
Bereich: -100E+24 bis 100E+24
*RST: 0
Nur Abfrage
CURSor:FUNCtion
auf Seite 358.
................................................................... 364
....................................................................... 364
Fernsteuerbefehle
Messkurvenanalyse
is set to MEASure.
362