Trigger:runt:maxwidth; Trigger:level :Slew:lower; Trigger:level :Slew:upper; Trigger:slew:slope - Rohde & Schwarz Scope Rider Rth Benutzerhandbuch

®
R&S Scope Rider RTH
Parameter:
<MinDuration>
TRIGger:RUNT:MAXWidth <MaxDuration>
Sets the upper time limit of the runt for comparisons WITHin and OUTSide.
Parameter:
<MaxDuration>
15.3.5.10 Anstiegszeitentrigger (R&S RTH-K19)
Siehe auch:
TRIGger:LEVel<m>:SLEW:LOWer
TRIGger:LEVel<m>:SLEW:UPPer
TRIGger:SLEW:SLOPe
TRIGger:SLEW:RANGe
TRIGger:SLEW:RATE
TRIGger:SLEW:DELTa
TRIGger:SLEW:MINWidth
TRIGger:SLEW:MAXWidth
TRIGger:LEVel<m>:SLEW:LOWer <Level>
TRIGger:LEVel<m>:SLEW:UPPer <Level>
Set the upper and lower voltage thresholds, respectively. The time measurement starts
when the signal crosses the first trigger level - the upper or lower level depending on
the selected slope. It stops when the signal crosses the second level.
Suffix:
<m>
Parameter:
<Level>
TRIGger:SLEW:SLOPe <Slope>
Sets the edge direction for the trigger.
Benutzerhandbuch 1326.1578.03 ─ 19
Bereich:
Inkrement: 100E-9
*RST:
Std.-einheit: s
Bereich:
Inkrement: 100E-9
*RST:
Std.-einheit: s
Kapitel 3.6.10, „Anstiegszeitentrigger (R&S
...................................................................................347
....................................................................................347
.................................................................................................. 347
..................................................................................................348
.....................................................................................................348
................................................................................................... 348
...............................................................................................348
..............................................................................................349
.
1..4
Indicates the trigger source: analog channel 1 to 4
Bereich:
Inkrement: 1E-3
*RST:
Std.-einheit: V
800E-12 bis 10000
5E-9
800E-12 bis 10000
5E-9
RTH-K19)",
-10 bis 10
0
Fernsteuerbefehle
Einrichten von Messkurven
auf Seite 74.
347