Verwendung; Bus:i2C:frame :Stop - Rohde & Schwarz Scope Rider Rth Benutzerhandbuch

®
R&S Scope Rider RTH

Verwendung:

BUS:I2C:FRAMe<m>:STOP?
Returns the end time of the specified frame.
Suffix:
<m>
Rückgabewerte:
<StopTime>
Verwendung:
15.11.3 SPI (Option R&S RTH-K1)
15.11.3.1 SPI-Konfigurationseinstellungen
BUS:SPI:SCLK:SOURce
BUS:SPI:SSEL:SOURce
BUS:SPI:MOSI:SOURce
BUS:SPI:MISO:SOURce
BUS:SPI:SCLK:SLOPe
BUS:SPI:SSEL:POLarity
BUS:SPI:TECHnology
BUS:SPI:SCLK:THReshold
BUS:SPI:SSEL:THReshold
Benutzerhandbuch 1326.1578.03 ─ 19
VOID
The frame is empty.
ADNack
Missing acknowledge bit after address - no slave recognizes the
address.
WRNack
Missing acknowledge bit after written data - the addressed slave
does not accept the written data.
SPERror
Stop error, no stop condition found.
STERror
Start error, no start condition found.
INSufficient
The frame is not completely contained in the acquisition. The
acquired part of the frame is valid.
*RST: OK
Nur Abfrage
.
*
Bereich: -100E+24 bis 100E+24
Inkrement: 100E-12
*RST: 0
Std.-einheit: s
Nur Abfrage
................................................................................................ 460
.................................................................................................460
.................................................................................................460
.................................................................................................460
...................................................................................................460
.................................................................................................460
.................................................................................................... 460
............................................................................................. 461
............................................................................................. 461
Fernsteuerbefehle
Protokollanalyse
459