Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 498

®
R&S Scope Rider RTH
BUS:SENT:CRCMethod
BUS:SENT:CRCVersion
BUS:SENT:DNIBbles
BUS:SENT:PPFLength
BUS:SENT:PPULse
BUS:SENT:SFORmat
BUS:SENT:RDSL
BUS:SENT:DATA:SOURce <Channel>
Sets the source of the data line. All channel waveforms can be used.
Parameter:
<Channel>
Verwendung:
BUS:SENT:POLarity <Polarity>
Sets the idle state.
Parameter:
<Polarity>
BUS:SENT:TECHnology <ThresholdType>
Sets the threshold values as defined for various signal technologies.
Parameter:
<ThresholdType>
BUS:SENT:DATA:THReshold <ThresholdValue>
Sets the threshold value for digitization of signals manually. If the signal value is higher
than the threshold, the signal state is high. Otherwise, the signal state is considered
low.
This value is only considered for
Parameter:
<ThresholdValue>
Benutzerhandbuch 1326.1578.03 ─ 19
..................................................................................................499
..................................................................................................499
......................................................................................................499
................................................................................................... 500
........................................................................................................500
..................................................................................................... 500
...........................................................................................................500
C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
C3 and C4: only R&S RTH1004
Digital channels are available if option R&S RTH-B1 is installed.
*RST: C1
Asynchroner Befehl
IDLLow | IDLHigh
*RST: IDLHigh
CMOS | USER
*RST: USER
BUS:SENT:TECHnology
Bereich: -400 bis 400
Inkrement: 1E-3
*RST: 1.4
Std.-einheit: V
Fernsteuerbefehle
Protokollanalyse
auf Seite 498 USER.
498