Uart-Konfiguration; Bus:uart:source; Bus:uart:polarity - Rohde & Schwarz Scope Rider Rth Benutzerhandbuch
Handheld-oszilloskop
®
R&S
Scope Rider RTH
Rückgabewerte:
<StopTime>
Verwendung:
15.11.4 UART/RS-232/RS-422/RS-485 (Option R&S RTH-K2)
●
UART-Konfiguration.............................................................................................. 467
●
UART-Trigger........................................................................................................ 470
●
UART-Decodierungsergebnisse............................................................................471
15.11.4.1
UART-Konfiguration
BUS:UART:SOURce <Channel>
Selects the input channel of the UART line.
Parameter:
<Channel>
BUS:UART:POLarity <Polarity>
Defines the logic states of the line. In idle high state, the idle state corresponds to a
logic 1, and the start bit to a logic 0. In idle low state, the idle state corresponds to a
logic 0, and the start bit to a logic 1. During idle time, no data is transmitted.
Parameter:
<Polarity>
Benutzerhandbuch 1326.1578.03 ─ 19
Bereich:
-100E+24 bis 100E+24
Inkrement: 100E-12
*RST:
0
Std.-einheit: s
Nur Abfrage
.......................................................................................................467
.......................................................................................................467
................................................................................................. 468
................................................................................................... 468
......................................................................................................... 468
....................................................................................................468
........................................................................................................469
.......................................................................................................... 469
..........................................................................................................469
............................................................................................................ 469
......................................................................................................... 469
................................................................................................ 470
...........................................................................................................470
C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
C3 and C4: only R&S RTH1004
Digital channels are available if option R&S RTH-B1 is installed.
*RST:
C1
IDLLow | IDLHigh
*RST:
IDLHigh
Fernsteuerbefehle
Protokollanalyse
467
Kapitel
