Can-Triggereinstellungen - Rohde & Schwarz Scope Rider Rth Benutzerhandbuch

®
R&S Scope Rider RTH
Fernsteuerbefehl:
BUS:CAN:SAMPlepoint
BUS:CAN:FDATa:ASAMplepoint
BUS:CAN:FDATa:DSAMplepoint

9.5.3 CAN-Triggereinstellungen

Zugriff: [Setup] ([Trigger]) > „Triggertyp" = „Bus"
CAN-Trigger................................................................................................................ 227
Frame-Typ...................................................................................................................227
ID-Typ..........................................................................................................................228
Kennungsmuster......................................................................................................... 228
Kennungsbezug.......................................................................................................... 228
FDF-Bit........................................................................................................................228
BRS-Bit....................................................................................................................... 229
ESI-Bit......................................................................................................................... 229
Datenmuster................................................................................................................229
Datenbezug.................................................................................................................229
Benutzerhandbuch 1326.1578.03 ─ 19
CAN und CAN FD (Optionen R&S RTH-K3, R&S RTH-K9)
auf Seite 475
auf Seite 475
auf Seite 476
Protokollanalyse
226