Messsteuerung - Rohde & Schwarz Scope Rider Rth Benutzerhandbuch

®
R&S Scope Rider RTH
Parameter:
<ReferenceValue>
METer<m>:SENSe:NULL:VALU <ReferenceValue>
Sets the reference value for the currently active measurement type.
Relative measurements are not available for diode, continuity, and frequency measure-
ments.
Suffix:
<m>
Parameter:
<ReferenceValue>

15.7.4 Messsteuerung

METer:SENSe:FUNCtion
METer:CONFigure:VALue?
METer<m>:TRIGger:MODE
METer<m>:ABORt
METer:SENSe:FUNCtion <MeasType>
Sets the measurement type and activates it. All measurement attributes of the previous
function (range, resolution, etc.) are remembered. If you return to the previous function,
the measurement attributes are restored.
Changing the measurement type disables scaling, limit testing, histogram, statistics,
and trend chart data collection: CALC:<function>:STAT is set OFF.
Einstellparameter:
<MeasType>
Beispiel:
Verwendung:
Benutzerhandbuch 1326.1578.03 ─ 19
Bereich: -200 bis 850
*RST: 0
Std.-einheit: To define the unit, use METer:UNIT:TEMPerature.
.
1..4
R&S RTH1002: always 1, omit the suffix
R&S RTH1004: Selects the voltmeter.
Bereich: +/- (1.1 * measurement range)
Std.-einheit: Depends on the measurement type
.................................................................................................411
............................................................................................. 412
............................................................................................ 412
......................................................................................................... 412
'CAPacitance | CONTinuity | CURRent:AC | CURRent[:DC] |
CURRent:AD | DIODe | FREQuency | RESistance |
TEMPerature | VOLTage:AC | VOLTage[:DC] | VOLTage:AD'
String parameter
*RST: VOLTage [:DC]
MET:SENS:FUNC "VOLT:AC"
MET:CONF:VAL?
<--"VOLT:AC 1"
Nur Einstellung
Fernsteuerbefehle
Digitalmultimeter (R&S RTH1002)
411