Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 322

®
R&S Scope Rider RTH
CHANnel<m>:THReshold:USER
CHANnel<m>:THReshold:THReshold?
CHANnel<m>:THReshold:FINDlevel
CHANnel<m>:STATe <State>
Switches the channel signal on or off.
Suffix:
<m>
Parameter:
<State>
CHANnel<m>:SCALe <Scale>
Sets the vertical scale (vertical sensitivity) of the indicated waveform.
Suffix:
<m>
Parameter:
<Scale>
CHANnel<m>:RANGe <Range>
Sets the voltage range across the 8 vertical divisions of the diagram. Use the com-
mand alternatively to CHANnel<m>:SCALe.
Suffix:
<m>
Parameter:
<Range>
CHANnel<m>:PROBe <ProbeSettings>
Sets the attenuation factor of the connected probe. The vertical scaling is adjusted
accordingly, and measured values are multiplied by this factor so that the displayed
values are equal to the actual signal values.
Benutzerhandbuch 1326.1578.03 ─ 19
..................................................................................... 326
............................................................................ 327
................................................................................ 327
.
1|2 (RTH1002) , 1..4 (RTH1004)
ON | OFF
*RST: OFF
.
1|2 (RTH1002) , 1..4 (RTH1004)
Scale value, given in Volts per division
Bereich: 2E-3 bis 100
Inkrement: 1E-3
*RST: 0.05
Std.-einheit: V/div
.
1|2 (RTH1002) , 1..4 (RTH1004)
Voltage range value
Bereich: 200E-9 bis 8E+6
Inkrement: 10E-6
*RST: 0.4
Std.-einheit: V
Fernsteuerbefehle
Einrichten von Messkurven
322