Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 442

®
R&S Scope Rider RTH
Parameter:
<Coupling>
LOGGer:CURSor:SCReen
Sets the cursors to a default position on the screen.
Verwendung:
15.10.3.2 Cursor-Ergebnisse
LOGGer:CURSor<m>:RESult<n>[:AMPLitude]?
LOGGer:CURSor:RESult<n>:DELTa?
LOGGer:CURSor<m>:POSition
LOGGer:CURSor:TDELta?
LOGGer:CURSor<m>:RESult<n>[:AMPLitude]?
Returns the measured value at the specified cursor line (y1 and y2 on the result dis-
play).
Suffix:
<m>
<n>
Rückgabewerte:
<Yvalue>
Verwendung:
LOGGer:CURSor:RESult<n>:DELTa?
Returns the difference of the measured values at cursor line 1 and cursor line 2 (Δy on
the result display).
Suffix:
<n>
Rückgabewerte:
<ResultDelta>
Verwendung:
Benutzerhandbuch 1326.1578.03 ─ 19
ON | OFF
*RST: OFF
Ereignis
................................................................442
.............................................................................. 442
.......................................................................................443
............................................................................................. 443
.
1..2
Specifies the cursor line.
1..4
Specifies the measurement. You can log the results of up to four
active measurements.
Measurement value
Nur Abfrage
.
1..4
Specifies the measurement. You can log the results of up to four
active measurements.
Absolute value of the result difference.
Nur Abfrage
Fernsteuerbefehle
Daten-Logger
442