Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 382

®
R&S Scope Rider RTH
SPECtrum:CURSor<m>:SCPLing
SPECtrum:CURSor<m>:FREQuency[:VALue]
SPECtrum:CURSor<m>:FREQuency:DELTa?
SPECtrum:CURSor<m>:LEVel[:VALue]?
SPECtrum:CURSor<m>:LEVel:DELTa?
SPECtrum:CURSor<m>:SCReen
SPECtrum:CURSor<m>:STATe <State>
Enables or disables the spectrum cursor measurement.
Suffix:
<m>
Parameter:
<State>
SPECtrum:CURSor<m>:SOURce <TraceSource>
Selects the trace on which the cursors are placed. Only active traces are available.
See:
●
SPECtrum:WAVeform:MAXimum[:ENABle]
●
SPECtrum:WAVeform:MINimum[:ENABle]
●
SPECtrum:WAVeform:SPECtrum[:ENABle]
●
SPECtrum:WAVeform:AVERage[:ENABle]
Suffix:
<m>
Parameter:
<TraceSource>
SPECtrum:CURSor<m>:COUPling <State>
Couples the cursor lines so that the distance between the two lines remains the same
if one cursor is moved.
Suffix:
<m>
Parameter:
<State>
Benutzerhandbuch 1326.1578.03 ─ 19
....................................................................................383
...................................................................383
...................................................................383
.......................................................................... 383
............................................................................ 384
.................................................................................... 384
.
1..2
ON | OFF
*RST: OFF
.
1..2
SPECtrum | MAXimum | MINimum | AVERage
*RST: SPECtrum
.
1..2
irrelevant
ON | OFF
*RST: OFF
Fernsteuerbefehle
Spektrumanalyse
auf Seite 381
auf Seite 381
auf Seite 381
auf Seite 381
382