Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 490

®
R&S Scope Rider RTH
Parameter:
<ThresholdValue>
BUS:LIN:TECHnology <ThresholdType>
Sets the threshold value for digitization of signals according to the specified techno-
logy. If the signal value is higher than the threshold, the signal state is high. Otherwise,
the signal state is considered low.
To set a user-defined threshold, select USER and define the value using
DATA:THReshold
Parameter:
<ThresholdType>
BUS:SETReflevels
Sets the appropriate threshold or threshold for the selected serial protocol.
Verwendung:
15.11.6.2 LIN-Trigger
TRIGger:LIN:CHKSerror
TRIGger:LIN:DATA
TRIGger:LIN:DCONdition
TRIGger:LIN:ICONdition
TRIGger:LIN:IDENtifier
TRIGger:LIN:IPERror
TRIGger:LIN:SYERror
TRIGger:LIN:TYPE
TRIGger:LIN:CHKSerror <ChecksumError>
Triggers on a checksum error if
Benutzerhandbuch 1326.1578.03 ─ 19
Bereich: -400 bis 400
Inkrement: 1E-3
*RST: 1.4
Std.-einheit: V
auf Seite 489.
TTL | ECL | CMOS | CAN | GND | LIN7vsupply | LIN12vsupply |
LIN18vsupply | USER
CMOS
2.5 V
LIN7vsupply | LIN12vsupply | LIN18vsupply
7 V / 12 V / 18 V
USER
Set the value with BUS:LIN:DATA:THReshold.
*RST: TTL
Ereignis
................................................................................................. 490
.........................................................................................................491
................................................................................................491
................................................................................................. 491
................................................................................................... 491
..................................................................................................... 492
.................................................................................................... 492
.........................................................................................................492
TRIGger:LIN:TYPE
Fernsteuerbefehle
Protokollanalyse
BUS:LIN:
is set to ERRC
490