Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 462

®
R&S Scope Rider RTH
BUS:SPI:TIMeout <FrameTimeout>
Sets the minimum idle time between two data frames. If the time interval between the
data frames is shorter, the words are part of the same frame. Within the timeout, the
data and clock lines are low. A new frame begins when the timeout has expired.
Timeout is only relevant if the bus has no chip select.
Parameter:
<FrameTimeout>
15.11.3.2 SPI-Trigger
TRIGger:SPI:MODE
BUS:SPI:SSEL:STATe
TRIGger:SPI:DSRC
TRIGger:SPI:DATA
TRIGger:SPI:DCONdition
TRIGger:SPI:DPOSition
TRIGger:SPI:MODE <TriggerType>
Selects the trigger type for SPI analysis.
Parameter:
<TriggerType>
BUS:SPI:SSEL:STATe <UseChipSelect>
Defines if the SPI bus uses a chip select line or not.
Parameter:
<UseChipSelect>
TRIGger:SPI:DSRC <DataSource>
Selects the line on which the trigger pattern is expected.
Parameter:
<DataSource>
Benutzerhandbuch 1326.1578.03 ─ 19
Bereich: 500E-9 bis 1000
Inkrement: 1E-3
*RST: 1E-3
Std.-einheit: s
....................................................................................................... 462
.................................................................................................... 462
........................................................................................................462
.........................................................................................................463
................................................................................................463
..................................................................................................463
FRST | FREN | DATA
FRST = frame start
FREN = frame end
DATA = data.
For details, see „SPI-Trigger (SPI Trigger)"
*RST: FRST
ON | OFF
*RST: ON
MISO | MOSI
*RST: MISO
Fernsteuerbefehle
Protokollanalyse
auf Seite 210.
462