Trigger:can:icondition; Trigger:can:identifier; Trigger:can:itype - Rohde & Schwarz Scope Rider Rth Benutzerhandbuch

®
R&S Scope Rider RTH
TRIGger:CAN:ICONdition <Relation>
Defines how the specified identifier pattern is compared with the acquired signal. The
instrument triggers if the acquired address is equal or unequal the defined pattern.
Parameter:
<Relation>
TRIGger:CAN:IDENtifier <Pattern>
Specifies the identifier pattern to be found, in binary format. Enter the pattern in MSB
first bit order.
Parameter:
<Pattern>
Beispiel:
TRIGger:CAN:ITYPe <IdentifierType>
Selects the length of the identifier.
Benutzerhandbuch 1326.1578.03 ─ 19
OVERload
When a node needs a delay between data and/or remote fra-
mes, it sends an overload frame.
DATA
The data frame is the only frame for actual data transmission.
REMote
Remote frames are only available in the CAN protocol.
The remote frame initiates the transmission of data by another
node. The frame format is the same as that of data frames but
without the data field.
DOR
Data frames or remote frames initiate the transmission of data
by another node. The frame format is the same as that of data
frames.
*RST: DOR
EQUal | NEQual
*RST: EQUal
String that contains the pattern in binary format. The parameter
accepts the bit value X (don't care).
TRIG:CAN:TYPE ID
TRIG:CAN:IDEN 001001
TRIG:CAN:ICON EQU
Triggers if the ID of the measured signal is 001001.
Fernsteuerbefehle
Protokollanalyse
479