Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 351

®
R&S Scope Rider RTH
TRIGger:SPATtern:CSOurce:FIRStedge
TRIGger:SPATtern:ORDer
TRIGger:SPATtern:PATTern
TRIGger:SPATtern:DSOurce[:VALue] <Source>
Selects the input channel of the data signal.
Parameter:
<Source>
TRIGger:SPATtern:CSOurce[:VALue] <Source>
Sets the input channel of the clock signal.
Parameter:
<Source>
TRIGger:SPATtern:CSOurce:EDGE <Slope>
Sets the edge at which the data value is sampled.
Parameter:
<Slope>
TRIGger:SPATtern:CSOurce:FIRStedge <FirstClockEdge>
Sets the edge at which the first bit of the pattern is sampled.
The command is required if
(double data rate).
Parameter:
<FirstClockEdge>
Benutzerhandbuch 1326.1578.03 ─ 19
...........................................................................351
.............................................................................................. 352
............................................................................................ 352
C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST: C1
C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST: C1
POSitive | NEGative | EITHer
POSitive
Rising edge
NEGative
Falling edge
EITHer
Rising and falling edges are considered (double data rate).
At double data rate, the edge at which the first bit of the pattern
is sampled is defined by
FIRStedge.
*RST: POSitive
TRIGger:SPATtern:CSOurce:EDGE
POSitive | NEGative | EITHer
*RST: POSitive
Fernsteuerbefehle
Einrichten von Messkurven
TRIGger:SPATtern:CSOurce:
is set to Either
351