Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 344

®
R&S Scope Rider RTH
15.3.5.8 Zustandstrigger (R&S RTH-K19)
Siehe auch:
TRIGger:STATe:CHANnel<m>
TRIGger:STATe:COMBination
TRIGger:STATe:CSOurce[:VALue]
TRIGger:STATe:CSOurce:EDGE
TRIGger:STATe:CHANnel<m> <State>
Sets the state of each input channel. The channel is specified by the channel suffix:
The logical combination of the channel states is defined by
COMBination.
Suffix:
<m>
Parameter:
<State>
TRIGger:STATe:COMBination <ChCombination>
Sets the logical combination for all active channels. The required state of each channel
is defined by TRIGger:PATTern:STATe[:CHANnel<m>].
Parameter:
<ChCombination>
TRIGger:STATe:CSOurce[:VALue] <Source>
Sets the input channel of the clock signal.
Parameter:
<Source>
TRIGger:STATe:CSOurce:EDGE <Slope>
Sets the edge of the clock at which the instrument checks the signal states.
Benutzerhandbuch 1326.1578.03 ─ 19
Kapitel 3.6.8, „Zustandstrigger (R&S
.........................................................................................344
..........................................................................................344
................................................................................... 344
..................................................................................... 344
.
1..4: analog channel 1 to 4
8..15: digital channels D0 to D7
ONE | ZERO | DONTcare
ONE
The signal value is above the defined threshold.
ZERO
The signal value is below the defined threshold.
DONTcare
The signal state does not matter.
*RST:
AND | OR
*RST:
C1 | C2 | C3 | C4 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST:
RTH-K19)",
DONTcare
AND
C1
Fernsteuerbefehle
Einrichten von Messkurven
auf Seite 72.
TRIGger:STATe:
344