Daten-Logger; Logger-Einstellungen - Rohde & Schwarz Scope Rider Rth Benutzerhandbuch

®
R&S Scope Rider RTH

15.10 Daten-Logger

●

Logger-Einstellungen............................................................................................ 436

● Skalierung............................................................................................................. 438
● Cursor im
● Zoom im
● Logger-Statistik..................................................................................................... 444
● Logger-Aufzeichnung............................................................................................447
15.10.1 Logger-Einstellungen
LOGGer:SOURce
LOGGer:TIMebase:SRATe
LOGGer:TIMebase:SCALe
LOGGer:SLOT:CURRent
LOGGer:SLOT:SLOT<m>:NAME
LOGGer:SLOT:SLOT<m>:HASData?
LOGGer:SLOT:SLOT<m>:STARt?
LOGGer:SLOT:LOAD
LOGGer:SLOT:CLEar
LOGGer:ACLR
LOGGer:SOURce <Source>
Sets the logger source.
Before you can change the logger source, stop the measurement.
Parameter:
<Source>
LOGGer:TIMebase:SRATe <NextSampleRate>
Sets the number of samples per second.
Parameter:
<NextSampleRate>
LOGGer:TIMebase:SCALe <NextHorizScale>
Selects the horizontal scale of the logged data.
Parameter:
<NextHorizScale>
Benutzerhandbuch 1326.1578.03 ─ 19
Logger-Modus...................................................................................... 441
Logger-Modus........................................................................................ 443
.......................................................................................................... 436
.............................................................................................. 436
..............................................................................................436
................................................................................................ 437
.....................................................................................437
............................................................................... 437
................................................................................... 438
..................................................................................................... 438
..................................................................................................... 438
.............................................................................................................. 438
SCOPe | METer | COUNter
SCOPe: an active automatic measurement is required.
METer | COUNter: The selected measurement must be active,
but not running.
SA1 | SA2 | SA5 | SA10
*RST: SA1
AUTO | S1 | S2 | S4 | S5 | S10 | S20 | S40 | M1 | M2 | M4 | M5 |
M10 | M20 | M40 | H1 | H2 | H4 | H5 | H10 | H20 | D1 | D2 | D4
Fernsteuerbefehle
Daten-Logger
436