Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 452

®
R&S Scope Rider RTH
The command takes effect if
Parameter:
<NoAckDataWrite>
TRIGger:I2C:ACCess <ReadWriteBit>
Toggles the trigger condition between read and write access of the master. Select
"Either" if the transfer direction is not relevant for the trigger condition.
The command takes effect if
Parameter:
<ReadWriteBit>
TRIGger:I2C:ACONdition <Relation>
Defines how the specified serial address pattern is compared with the acquired signal.
The instrument triggers if the acquired address is equal or unequal to the pattern.
Parameter:
<Relation>
TRIGger:I2C:ADDRess <Pattern>
Specifies the address pattern to be found in binary format. Enter the pattern in MSB
first bit order.
Parameter:
<Pattern>
Beispiel:
TRIGger:I2C:DATA <Pattern>
Defines the data pattern as trigger condition. Enter the words in MSB first bit order.
Parameter:
<Pattern>
Benutzerhandbuch 1326.1578.03 ─ 19
TRIGger:I2C:MODE
ON | OFF
*RST: ON
TRIGger:I2C:MODE
READ | WRITe | EITHer
*RST: EITHer
EQUal | NEQual
*RST: EQUal
String with max. 7 or 10 characters, depending on the address
length. Characters 0, 1, and X are allowed. If you define a pat-
tern shorter than the address length, the missing LSB are filled
with X.
TRIG:I2C:ADDR "10110"
Sets the 7 bit address pattern 10110XX.
String with max. 4 bytes in binary format. Characters 0, 1, and X
are allowed. If you define a pattern with incomplete byte, the
missing LSB are filled with X.
Fernsteuerbefehle
Protokollanalyse
is NACK.
is ADDRess or ADAT.
452