Uart-Trigger; Bus:uart:framemode; Bus:uart:tout - Rohde & Schwarz Scope Rider Rth Benutzerhandbuch

®
R&S Scope Rider RTH
Parameter:
<BitOrder>
BUS:UART:FRAMemode <FrameMode>
IDLE defines frames of several words in the data stream, which are defined by a time-
out between a stop bit and the next start bit. Enter the minimum timeout between two
frames using BUS:UART:TOUT.
Parameter:
<FrameMode>
BUS:UART:TOUT <IdleTime>
Sets the minimum timeout between two frames if
IDLE.
Parameter:
<IdleTime>
15.11.4.2

UART-Trigger

TRIGger:UART:TYPE
TRIGger:UART:DATA
TRIGger:UART:DCONdition
TRIGger:UART:TYPE <TriggerType>
Selects the trigger type for UART analysis.
Parameter:
<TriggerType>
Benutzerhandbuch 1326.1578.03 ─ 19
LSBF | MSBF
*RST: MSBF
NONE | IDLE
*RST: NONE
Bereich: 100E-9 bis 1
Inkrement: 1E-3
*RST: 1E-3
Std.-einheit: s
..................................................................................................... 470
..................................................................................................... 471
............................................................................................ 471
STBT | PCKS | DATA | PRER | STPerror | BRKC
STBT = start bit
PCKS = frame start
PRER = parity error
STPerror = stop error
BRKC = break condition
DATA:: data. To set up the trigger condition, use
UART:DATA, and TRIGger:UART:DCONdition.
For details, see „UART-Trigger (UART Trigger)"
*RST: STBT
Fernsteuerbefehle
Protokollanalyse

BUS:UART:FRAMemode

TRIGger:
auf Seite 217.
is set to
470