Trigger:pattern:state[:Channel ] - Rohde & Schwarz Scope Rider Rth Benutzerhandbuch
Handheld-oszilloskop
®
R&S
Scope Rider RTH
TRIGger:EXTernal:LEVel <Level>
Sets the trigger voltage level.
Parameter:
<Level>
TRIGger:EXTernal:SLOPe <Slope>
Sets the edge direction for the trigger. You can trigger on the rising edge, the falling
edge, or riding and falling edges of the external signal.
Parameter:
<Slope>
15.3.5.7
Mustertrigger (R&S RTH-K19)
Siehe auch:
TRIGger:PATTern:STATe[:CHANnel<m>] <State>
Sets the state of each input channel. The channel is specified by the channel suffix:
The logical combination of the channel states is defined by
STATe:COMBination.
Suffix:
<m>
Parameter:
<State>
Benutzerhandbuch 1326.1578.03 ─ 19
Bereich:
Inkrement: 1E-3
*RST:
Std.-einheit: V
POSitive | NEGative | EITHer
*RST:
Kapitel 3.6.7, „Mustertrigger (R&S
....................................................................................342
....................................................................................342
................................................................................... 343
..................................................................................... 343
.................................................................................343
................................................................................343
.
1..4: analog channel 1 to 4
8..15: digital channels D0 to D7
ONE | ZERO | DONTcare
ONE
The signal value is above the defined threshold.
ZERO
The signal value is below the defined threshold.
DONTcare
The signal state does not matter.
-10 bis 10
0
POSitive
RTH-K19)",
.......................................................................... 341
.............................................................................342
Fernsteuerbefehle
Einrichten von Messkurven
auf Seite 69.
TRIGger:PATTern:
341
Kapitel
