Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 412

®
R&S Scope Rider RTH
METer:CONFigure:VALue?
Returns the actual measurement type (short form) and the range.
Rückgabewerte:
<Configuration>
Beispiel:
Verwendung:
METer<m>:TRIGger:MODE <TriggerMode>
Defines how long the instrument measures. To start the measurement again, use RUN
or the appropriate METer<m>:MEASure:<function> command.
Suffix:
<m>
Parameter:
<TriggerMode>
METer<m>:ABORt
Stops the running measurement.
Suffix:
<m>
Verwendung:
15.7.5 Ergebnisse
● Werte
● METer:MEASure-Befehle...................................................................................... 414
● Statistik..................................................................................................................415
Benutzerhandbuch 1326.1578.03 ─ 19
String parameter
MET:CONF:VAL?
<--"VOLT:DC 100"
The DMM is set to DC voltage measurement and range 100 V.
Nur Abfrage
.
1..4
R&S RTH1002: always 1, omit the suffix
R&S RTH1004: Selects the voltmeter.
AUTO | SINGle
AUTO
The instrument performs continuous measurements.
SINGle
The instrument performs a single measurement.
*RST:
.
1..4
R&S RTH1002: always 1, omit the suffix
R&S RTH1004: Selects the voltmeter.
Ereignis
lesen........................................................................................................... 413
Digitalmultimeter (R&S RTH1002)
AUTO
Fernsteuerbefehle
412