Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 439

®
R&S Scope Rider RTH
LOGGer:AUToset
Sets all logger channels to automatic scaling.
Verwendung:
Firmware/Software: FW 1.60 and higher
LOGGer:MEASurement<m>:VERTical:AUTO [<State>]
Enables or disables the vertical auto scaling for the specified logger channel.
Using the command without parameter performs auto scaling once, without changing
the state.
Suffix:
<m>
Parameter:
<State>
Beispiel:
Firmware/Software: FW 1.60 and higher
LOGGer:MEASurement<m>:VERTical:UPPer <Upper>, [<Lower>]
LOGGer:MEASurement<m>:VERTical:LOWer <Lower>, [<Upper>]
Set the upper and lower range limits for the specified logger channel. The values must
differ. You can set both values using only one of the commands (see examples). The
query returns the mandatory parameter.
The commands disable the vertical auto scaling.
Suffix:
<m>
Parameter:
<Lower>
Einstellparameter:
<Upper>
Beispiel:
Benutzerhandbuch 1326.1578.03 ─ 19
Ereignis
.
1..4
Logger channel
ON | OFF
*RST: ON
LOGGer:MEASurement1:VERTical:AUTO 0
LOGGer:MEASurement1:VERTical:AUTO
LOGGer:MEASurement1:VERTical:AUTO?
<-- 0
.
1..4
Logger channel
Lower range limit
Upper range limit
Set the lower value to -1 and the upper value to +1 using both
commands:
LOGGer:MEASurement1:VERTical:LOWer -1
LOGGer:MEASurement1:VERTical:UPPer +1
Fernsteuerbefehle
Daten-Logger
//sets manual scaling for ch1
//autoscales logger channel 1
//state is unchanged (off)
439