Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 361

®
R&S Scope Rider RTH
CURSor:STATe <State>
Enables or disables the cursor measurement.
Parameter:
<State>
CURSor:FUNCtion <Type>
Defines the type of the cursor measurement.
Parameter:
<Type>
CURSor:SOURce <Source>
Defines the source on which the cursor measurement is performed. The source setting
is not relevant for the vertical cursor type.
Parameter:
<Source>
CURSor:COUPling <Coupling>
Couples the cursor lines so that the distance between the two lines remains the same
if one cursor is moved.
Parameter:
<Coupling>
CURSor:SCPLing <ScaleCoupling>
If ON, the position of the cursor lines is adjusted if the vertical or horizontal scales are
changed. If OFF, the cursor lines remain on their position on the display if the scaling is
changed.
Parameter:
<ScaleCoupling>
CURSor:SCReen
Sets the cursors to a default position on the screen.
Benutzerhandbuch 1326.1578.03 ─ 19
ON | OFF
*RST: OFF
VERTical | HORizontal | TRACking | MEASure
See Kapitel 4.3.2, „Cursor-Typen und
*RST: VERTical
C1 | C2 | C3 | C4 | M1 | D0 | D1 | D2 | D3 | D4 | D5 | D6 | D7
*RST: C1
ON | OFF
*RST: OFF
ON | OFF
*RST: OFF
Fernsteuerbefehle
Messkurvenanalyse
Ergebnisse", auf Seite 96.
361