Rohde & Schwarz Scope Rider RTH Benutzerhandbuch Seite 497

®
R&S Scope Rider RTH
Beispiel:
Verwendung:
BUS:LIN:FRAMe<m>:SYSTate?
Returns the synchronization state of the frame.
Suffix:
<m>
Rückgabewerte:
<FrameSyncState>
Verwendung:
15.11.7 SENT (Option R&S RTH-K10)
● SENT-Konfigurationseinstellungen....................................................................... 497
● SENT-Trigger........................................................................................................ 501
● SENT-Decodierungsergebnisse............................................................................503
15.11.7.1 SENT-Konfigurationseinstellungen
BUS:SENT:DATA:SOURce
BUS:SENT:POLarity
BUS:SENT:TECHnology
BUS:SENT:DATA:THReshold
BUS:SENT:CLKPeriod
BUS:SENT:CLKTolerance
Benutzerhandbuch 1326.1578.03 ─ 19
BUS:LIN:FRAMe2:SYMBol?
Response: Temperature
Nur Abfrage
.
*
OK | STERror | SPERror | PRERror | UVAL | NOEXists |
INSufficient
OK
The frame is valid.
SPERror
Stop error, no stop condition found.
STERror
Start error, no start condition found.
PRERror
Parity error, which indicates a transmission error
UVAL
Unexpected value
NOEXists
Byte does not exist.
INSufficient
The frame is not completely contained in the acquisition. The
acquired part of the frame is valid.
*RST: OK
Nur Abfrage
..............................................................................................498
.......................................................................................................498
................................................................................................. 498
.......................................................................................... 498
....................................................................................................499
............................................................................................... 499
Fernsteuerbefehle
Protokollanalyse
497