Measuring Parameters; Transmitter Types; Parameter List - Grundfos Control DDD Montage- Und Betriebsanleitung

Command Description
With this configuration command, you can add a
number to the CIM 250 phone number list. The number
must be of international format with "+" followed by the
country code and the local number. In the case of local
numbers, "+" and the country code are not required.
Up to four numbers can be stored.
When a number has been added, CIM 250 will
acknowledge the change with this message:
ADDNUMBER: <phone number> added
to the phone number list
The message will be sent to both the sender of the
command and to the phone number which has been
ADDNUMBER
added. If the parameter is omitted, the phone number
[phone
of the sender will be added.
number]
When CIM 250 has been initialised, only the number of
the mobile phone used for initialisation will be in the
internal phone number list of the module.
To see the phone number list, use the command
"LIST".
Note: If all phone numbers are deleted, make sure that
the access option is not "LIST", as this would leave
CIM 250 unaccessible and require a hardware reset
(press the reset button for five seconds) followed by a
reconfiguration. For further information about
hardware reset, see installation and operating
instructions for the CIM 2XX GSM module.
With this configuration command, you can set whether
CIM 250 is to accept roaming or not. CIM 250 will
acknowledge the change with this message:
ROAMING: changed to <ON | OFF>
ROAMING <ON |
If roaming is set to "OFF", this will apply to both GSM,
OFF>
SMS and GPRS. If roaming is set to "ON", this will
apply to GSM and SMS , whereas roaming for GPRS
will only be allowed if "GPRSROAMING" has also
been set to "ON".
Default setting: ON.
With this configuration command, you can delete a
number in the CIM 250 phone number list.
If the number exists, it will be deleted, and CIM 250 will
acknowledge the change with this message:
DELNUMBER: <phone number>
deleted from the phone number
list
The message will be sent to both the sender of the
command and to the phone number which has been
deleted.
If the parameter is omitted, the phone number of the
sender will be deleted.
DELNUMBER If the parameter is "ALL", all phone numbers will be
[phone number
deleted, and CIM 250 will send this message:
| ALL]
DELNUMBER: Phone number list
empty
To see the phone number list, use the command
"LIST".
Note: If all phone numbers are deleted, make sure that
the access option is not "LIST", as this would leave
CIM 250 unaccessible and require a hardware reset
(press the reset button for five seconds) followed by a
reconfiguration. For further information about
hardware reset, see installation and operating
instructions for the CIM 2XX GSM module.
Numbers can be reset by pressing the reset button for
five seconds.

9. Measuring parameters

9.1 Transmitter types

The transmitter types in the table below can be used for the
measurement of values in the system.
Abbreviation Transmitter
FT Flow transmitter
PT Pressure transmitter
RPT Remote sensor

9.2 Parameter list

The table below shows which measured values CU 354 can
receive via its analog inputs. Figure
can be measured.
Number Parameter
1 Flow rate
2 Outlet pressure
3 Pressure, critical point
2
Fig. 132 Pressure boosting
132 shows where the values
1
3
65