Read/Write Data Carrier; Parameter Setting - Balluff BIS U-6127-081-1 4-06-ST36 Betriebsanleitung

BIS U-6127-081-1_4-06-ST36
Processor unit
7
Startup and operation (continued)
7.1.5

Read/write data carrier

The R / tab provides the functions for reading out
ead wRite
and writing to data carriers. The desired action can be
started via the R and w
ead
data carrier can be processed, it must be detected in the
d tab.
etect
Memory area via which the TAG is to be identified
The EPC and TID of the data carrier can be used to select
an individual data carrier. An individual data carrier can be
selected via the respective drop-down list.
Right-click on a data carrier in the list to switch
directly to the R
interactions with the selected data carrier can
be performed.
a
cceSS paSSwoRd
By selecting the a
cceSS paSSwoRd
appears in which an access password can be entered.
This function is only intended for data carriers that are
secured by an access password.
Which memory area should be processed?
Selection of the memory area to be read or written to.
The epc, tid, R and u
eSeRved
for selection. Details on the memory areas and their size
can be found in the data sheet of the data carriers used.
For the epc and tid data, the
fixed.
For direct access to the memory banks of epc, tid,
R as well as the u
eSeRved SeR data
and l (number of bytes) can be defined via the input
ength
fields provided.
Memory Read Write
area
epc Yes Yes
tid Yes No
u Yes Yes
SeR data
Data
The data read out is displayed in the d
area of the data field shows the start addresses of the
individual lines. The middle area shows the data in hex
format. The right area shows the ASCII representation of
the data. Data to be written can be edited directly in the
data field by keyboard input (in hex or ASCII format).
32 english
buttons. Before an individual
Rite
/w tab. There, further
ead Rite
check box, an input field
areas are available
SeR data
and
StaRt addReSS length
area, the S
taRt addReSS
Start Length
address
Fixed Parame-
ters
Fixed Parame-
ters
S l
taRt ength
field
addReSS
field
field. The left
ata
Manipulate data
For simple data values, the buttons i
and f
c
ontinuouS ixed value
field, a start value for the c
v
alue
value for the f
ixed value
Load/save data
Via the buttons o
pen
can be exported to a file (*.dat) or imported from a file.
7.1.6

Parameter setting

Depending on the active security level, various settings can
be made under p
aRameteRS
The meaning of the individual parameters and their
assignment to the UHF Manager are described in
chapter 7.3 on page 49.
The S BiS and R
end to
to transmit the parameters to or read them from the
processor unit.
The S ... and o
ave aS
parameter sets in an xml file or to read them in from an xml
file. This procedure simplifies the parameterization if several
devices are to receive the same parameterization.
The d
efault SettingS
interface to the values of the delivery state. The S
BiS button can be used to transfer the parameters to the
processor unit.
are
, d
ncRement ecRement
can be used. In the S
taRt value
function or a
ontinuouS
function can be specified.
or S , the hex data of the data field
ave
... and a
dvanced paRameteRS
BiS buttons can be used
eceive fRom
... buttons can be used to save the
pen
button initially only resets the user
end to
,
/
....