Rfid - Balluff BIS U-6127-081-1 4-06-ST36 Betriebsanleitung

BIS U-6127-081-1_4-06-ST36
Processor unit
7
Startup and operation (continued)
7.2.4

RFID

Start scan, Read/write
The RFID menu can be called up via the main menu bar
(see Fig. 7-4 on page 33).
a Scan list
b
Antenna status
c Update interval
d
Start address
e Length (byte)
Fig. 7-8: RFID
On this page, tag operations like S
and R d can be performed (see Fig. 7-8).
ead ata
On the right side, the a
ntenna
active antennas and their powers. These values can be
changed for tag scanning on this page. Furthermore, the
u i (c) shows the duration between two scans.
pdate nteRval
The and the u
antenna StatuS pdate
to perform the desired scan.
On the left side of the page, the scan list (a) is created in
tabular form with EPC, count (how many times the tag was
scanned), RSSI and antenna (a selection sign represents
each antenna that scanned the tag).
www.balluff.com
S , w d
taRt can Rite ata
S (b) shows the globally
tatuS
i can be changed
nteRval
f Password
g
Memory bank
h EPC of the selected data carrier
i
Data content at selected address and memory bank
Input parameters for the tag read and tag write operations:
– The start address (d) from which the read/write must
begin.
– Length of the bytes to be read (e).
– Password (f) to read/write the tag.
– The memory bank (g) from which data must be read/
written.
In addition, d t
ownload ag liSt
scanned tag list as a comma separated values (CSV) file.
In the upper right corner, information is displayed in red
color, e.g. Read completed successfully.
allows you to download the
english 35