BIS U-6127-081-1_4-06-ST36
Processor unit
7
Startup and operation (continued)
Antennas & power
Fig. 7-14: Antennas & power
Parameters for antennas & power:
To change settings of the following parameters,
the a
authorization level is required.
dmin
–
(a) Active antennas (Parameter 0012
–
(b) For antenna type, see section UHF components on
page 73
–
(c) Antenna gain (Parameter 0013
–
(d) For cable type see section UHF components on
page 73
–
(e) Cable attenuation (Parameter 0014
page 75
To change settings of the following parameters,
at least the e
xpeRt
–
(f) Transmitting power on read (default) (Parameter
0008
) see page 58
hex
–
(h) Automatic increase of transmitting power on write
(Parameter 0009
) see page 59
hex
–
(i) Starts the Auto-Setup function for the corresponding
antenna (Parameter 1003
The following parameter is calculated from the other
parameters and cannot be changed directly:
–
(g) Displays the calculated transmitting power at the
antenna jack.
38
english
) see page 74
hex
) see page 74
hex
) see
hex
authorization level is required.
) see page 60
hex