Balluff BIS U-6127-081-1 4-06-ST36 Betriebsanleitung Seite 204

BIS U-6127-081-1_4-06-ST36
Processor unit
6
Application planning (continued)
Mode Device auto-
matically
scans for
tags
Synchronous –
Asynchronous
+
(incl. loop filter)
Synchronous
+ loop filter, +
Live
Synchronous
+ loop filter, +
cumulative
Autonomous
+
operation
The cumulative mode can be set via the protocol, but not via the UHF
1)
Manager.
The UHF Manager can start or stop autonomous operation. However, it
2)
cannot display the outputs of autonomous operation, since they take
place on a 2nd channel.
If a loop filter is required in autonomous operation, it must be
3)
reactivated after each device restart and autonomous operation must
be reactivated.
With OPC UA, autonomous operation must be reactivated after each
4)
device restart.
If the loop filter is active, no values from the TID, password or user data
5)
area can be output in formatted output. Only data from the EPC bank
(EPC, protocol control word) and status values can be output.
28 english
Usable with
007 proto- OPC UA
col
+ +
+ +
+ +
+ –
1)
+ +
2), 3) 4)
Formatted
reading
Web inter-
usable
face
+ +
– –
– +
5)
– +
5)
– +
2nd channel 2nd channel
possible needed
(007, for-
matted)
+ –
– –
+ –
+ –
+ +