Command Overview - Balluff BIS U-6127-081-1 4-06-ST36 Betriebsanleitung

BIS U-6127-081-1_4-06-ST36
Processor unit
8
007 protocol (continued)
8.5

Command overview

General commands
Function Command
recognition
ASCII
Abort 'Q'
System 'q'
Reboot
Read network 'm'
parameters
Change 'j'
network
parameters
Read trans- 'o'
mitting power
Change 'p'
transmitting
power
Read device 'G'
parameters
Change 'E'
device para-
meters
Read version 'V'
www.balluff.com
Description
HEX
51 Abort asynchro-
hex
nous commands.
71 System reboot
hex
6D Read Ethernet
hex
network parame-
ters.
6A Set Ethernet
hex
network parame-
ters.
6F Read out transmit-
hex
ting power of
specified antenna.
70 Set transmitting
hex
power of specified
antenna.
47 Read out device
hex
parameters.
45 Set device para-
hex
meters.
56 Read out informa-
hex
tion on processor
unit.
– BIS U type
designation
– Hardware
version/
firmware
version/serial
number
– IO-Link FW
version
Detect data carriers
Function Command
recognition
ASCII
Number of 'N'
data carriers
Detect data 'M'
carriers
Detect data ','
carriers,
extended
Asynchronous messages, Tag goes/Tag comes
Function Command
recognition
ASCII
Data carrier <DLE> 102B
comes, event '+'
Data carrier <DLE> 102D
goes, event '−'
Description
HEX
4E Query the number
hex
of tags that are
within the detec-
tion range of the
specified antenna.
4D Detects the data
hex
carriers that are in
the detection range
of the specified
antenna and
returns a list of the
requested data
(EPC or TID).
2C Detects the data
hex
carriers that are in
the detection range
of the specified
antenna and
returns a list of the
requested data
(EPC or TID) and
additional informa-
tion.
Description
HEX
Reports a tag as
hex
Comes when it
enters the detec-
tion range.
Reports a tag as
hex
Goes when it
leaves the detec-
tion range.
english 91