Resetting Ethernet Network Settings (Dhcp), Enabling Fixed Ip; Address - HBM ClipX Bedienungsanleitung

Starting up the ClipX
between 1 and 254. The last group of numbers must not match the one on
the HBM device.
4. For subnet mask enter the same digit groups as those available on the
HBM device.
5. Then click OK to close all open dialogs. You may have to restart the PC to
activate the setting.
Example
The IP address of the ClipX is 192.168.169.80, the subnet mask is
255.255.255.0.
Enter 192.168.169.123 as the IP address and 255.255.255.0 as the subnet
mask on the PC.
7.2.4

Resetting Ethernet network settings (DHCP), enabling fixed IP

address

You can reset the Ethernet network settings (and only them) to their factory
defaults or enable the fixed (static) IP address 192.168.0.234 (from firmware
2.0). In both cases you must press the Reset button on the front of the ClipX
while powering up.
You can also use the Reset button to temporarily disable user man-
agement – see also
80
"User Management" on page
A04643_04_X00_03 HBM: public
82.
ClipX