Possible Cases And Their Effects When Connected Via Ethernet - HBM ClipX Bedienungsanleitung

Notes
• In Windows XP only the name resolution under NetBIOS is available.
• For name resolutions via NetBIOS, you should only ever connect one ClipX
as long as you have not changed the device names.
• UPnP is only available as from Windows 7.
• Avahi or Zeroconf (similar to Bonjour) is only available if a corresponding
service, such as Bonjour print services, is installed.
See also
on page
7.2.2

Possible cases and their effects when connected via Ethernet

When connecting between the PC and ClipX the following cases may arise:
1. No server in the network, the PC has no address (DHCP is used), and the
ClipX is likewise set to DHCP (factory default setting).
When using Windows XP or higher, temporary addresses are automatically
assigned by the PC (APIPA), the ClipX connection can be made.
2. No server in network, PC has no setting or is using DHCP, the ClipX has a
fixed address
No connection can be established with this combination.
3. No server in the network, PC and ClipX have a fixed address
A connection can normally be made only if the addresses of the PC and
ClipX are in the same network segment and both are using the same subnet
mask.
4. DHCP server in network, PC has a fixed address or uses DHCP, the ClipX
has a fixed address.
A connection can normally be made only if the addresses of the PC and
ClipX are in the same network segment.
5. DHCP server in network, PC and ClipX are using DHCP
The connection can be established.
ClipX
"Possible cases and their effects when connected via Ethernet"
77, "Set Ethernet address of PC" on page
A04643_04_X00_03 HBM: public
Starting up the ClipX
78.
77