Data Transfer From The Clipx To The Controller - HBM ClipX Bedienungsanleitung

The following table shows the bit assignment of the object value (value field)
when accessing the object dictionary.
Bit 31 ... 24
9.4

Data transfer from the ClipX to the controller

See also "Data types used by the ClipX" on page
The following table sets out the data and the speed at which the data are
updated by the ClipX in the event of a change. The speed (cycle in ms) is not
synchronized with the fieldbus, or with PROFINET IRT or EtherCAT Distributed
Clocks.
Designa-
tion
Electrical
value (field
value)
Gross value
Net value
Minimum
value
Maximum
value
Peak-to-
Peak (Peak-
to-peak)
ClipX
Bit 23 ... 16
Data object types UDINT, DINT, REAL, FLOAT
Not used
Not used
Cycle in
Format
ms
FLOAT 0.52
A04643_04_X00_03 HBM: public
Bit 15 ... 8
Data object types INT, UINT
125.
Explanation
Input signal in the unit of the measured vari-
able, e.g. in mV/V.
Gross signal.
Net signal.
Peak value minimum.
Peak value maximum.
Peak value peak-to-peak.
Operation via fieldbus
Bit 7 ... 0
Data object types
SINT, USINT
129