Calculation Functions - HBM ClipX Bedienungsanleitung

Starting up the ClipX
Procedure
1. Select the Mode.
2. Choose whether you want to enter the reference values manually or import
them.
3. Either enter the reference values (the unit will be applied from the Amplifier
menu, though you can change it here) or specify the signal source for the
reference values (e.g. from the ClipX bus).
4. Start the measurement.
In static measuring mode, the sensor is first measured under no load. Then
you must apply a load to the sensor and start the second measurement.
You can stop dynamic measuring mode when the minimum and maximum
values have been reached at least once.
5. When the measurements are complete, you can either accept the measured
values and click
The already measured values will then be set off against the new values
(averaging).
The window closes when you click APPLY.
7.4.2

Calculation functions

Specify your calculations by choosing Calculated Channels from the menu.
You can create up to six calculations, and output up to six result channels plus
eight digital flags (the 6x6-matrix calculation already delivers up to six result
channels). Each calculation is executed 1000 times per second.
Procedure
1. Click on one of the six lines at the top of the window under Function
Blocks.
2. Select one of the calculation functions under Select Function Type.
3. Select the inputs or numerical values you want.
If you need more constants than those already available (internal con-
stants), you must first specify the number at the bottom of the window in the
User-defined Constants area. You can create up to 10 custom constants
and assign them suitable names.
86
APPLY or start a new measurement cycle.
A04643_04_X00_03 HBM: public
ClipX